Vicork is an eco-friendly insulator, made from a combination of recycled rubber tires and portuguese prime material cork, is a cost effective and versatile product.
- Levertijd:
- Op Aanvraag
Vicork is an eco-friendly insulator, made from a combination of recycled rubber tires and portuguese prime material cork, is a cost effective and versatile product. Designed for floor installations, the Vicork is placed between the concrete and the final floor finish. It is also a quick solution for pro-audio, industrial, residential and commercial applications.
Product
The dimpled (wave textured) agglomerated cork underlay for healthy flooring.
Moisture
Agglomerated cork.
Features
- Prevents Mould Grouth
- High Durability and Long Term Resilience
- Environmental friendly (100% natural and sustainable)
- Increases Floor Thermal Insulation
General Installation Instructions
The following installation instructions are recommended by Vicoustic, but are not intended as a definitive project specification. They are presented in an attempt to be used with recommended installation procedures of the flooring manufacturers.
Environmental Conditions
Temperature >10ºC / Room moisture content <75%.
Subfloor
All subfloor work should be structurally sound, clear and level. The moisture content of the subfloor should not be more than 2.5% (CM) by weight measured on concrete subfloors.
Insulation vapour barrier
A p.e. insulation vapour barrier covering the entire flooring area, minimum 50mm wide vertically around the perimeter of the entire floor must be installed prior to the Vicork C31.
Install by overlapping (minimum 100mm) the p.e. foil, and use an adequate tape to adhere/fix it, if necessary. After completion, p.e. foil should cover the entire concrete area without gaps. Never mechanically fasten the p.e. foil barrier with screws, nails or staples as this will severely diminish the performance of the insulation barrier.
Installation Instruction for Vicork C31
Unpack the Vicork C31 at least 24 hours before the installation and store it in the room where the installation will take place. Cut the C31 to desired length and install directly over the entire floor pulled 30mm up the walls with crown of the rolled materials up (Vicork label side down), removing all traped air. After completion, the C31 should cover the entire flooring area without gaps and with joints butted tight and preferably taped.
Final Flooring
Always follow manufacturer's recommended installation instructions.
Important Notes
Never mechanically fasten the Vicork C31 to the flooring floor as this will severaly diminish its acoustical value.
Main Info
Ref: U01047
EAN13: 5600301854231
HS Code: 45041091
Dimensions: 10000 x 1000 x 3 mm
Performance
Thermal Conductivity: 0.38 W/mK
Shipping
Units per Box: 1
Box Weight: 4.8 kg
